Recessed Lighting Installation
General Tools and Materials:
Printable PDF of Recessed Lighting Installation Instructions- Light Fixtures
- Jig Saw with Finish Blade
- Screw Gun / Drill Driver & Bits
- Pencil
- Safety Glasses
Installation Overview
WARNINGS
- Consult a licensed electrician if your installation requires electrical work that you are unfamiliar with.
- Follow local building and fire codes as well as the light manufacturer’s recommended clearances.
- Turn electricity off prior to starting any electrical work.
- Pull all electrical prior to installing the beam and lights.
- Wear safety glasses during the entire installation process.
Click Here for Care and Maintenance info.
Directions
Step 1
Measure Beam
Ensure your fixture has adequate clearance inside the beam.
Step 2
Mark Location of the Hole
Tools:
- Pencil
Determine the location of your light. Mark the cut based on the light manufacturers instructions/template.
Step 3
Cut Holes
Tools:
- Safety Glasses
- Jig Saw with Finish Blade
- Screw Gun/Drill Driver & Drill Bits
- Driver Bits
Step 4
Install Beam
Tools:
- Safety Glasses
- Screw Gun/Drill Driver & Drill Bits
Install the beam based on the appropriate installation guide over the electrical work. Ensure that all electrical has been pulled prior to gluing and screwing the beam in place.
Step 5
Connect the Light Fixture to the Electrical Supply
Tools:
- Safety Glasses
- Light Fixtures
Step 6
Insert Fixture
Tools:
- Safety Glasses
- Light Fixtures
Insert fixture into the beam and finish according to light fixture manufacturer instructions.